My md802 shows the MAF readings in lb/s instead of lb/min. No manufacture that I am aware of gives the MAF readings in lb/s they are either lb/min or g/sec. Is there anyway you can have this changed in the next update.

Would be nice if you could allow in setup the option to select the units of measurement for individual sensors such as MAP, Baro, MAF and the temp sensors.

I do not want to have to back out of the live data to get into the setup and have to change the units to metric and then have to go back into live data to be able to read the measurements.

file:  MAF.jpg

 You are missing my point. Yes the MAF readings will be in g/s if I select metric but then everything else will be in metric also. I do not want to have to back out of the live data and switch to metric and then back to English everytime I need to read certian measurements.

My snap-on MT2500 which is 20 years old allows the user to select gm/s or lbs/min for the MAF reading.

Besides the English MAF reading should NEVER be in lb/s anyway. The proper english MAF reading should be in lb/min NOT lbs/s.